48
5. Repeat the last three steps on the left side of the bike.
6. Using a #2 Phillips screwdriver, remove the indicated hardware from
the Drive Belt Cover. Carefully remove the Drive Belt Cover and set it
safely aside for reassembly.
Note: The oval indicates the two machine screws with washers.
Drive Belt Cover
Note: Please disregard the Right Crank Arm in the above
image. It was removed during an earlier step.
7. Record the number of threads showing on the Tensioner Eyebolt on
each side of the Tensioner Support Bracket.
8. Using a 10mm wrench, loosen the outer Flywheel Retainer Nut on
both sides of the machine. Loosen the outer Flywheel Retainer Nut until
there is a visible slack in the Drive Belt. This will ease the removal of the
Drive Belt from the Drive (Crank) Pulley.
Flywheel Bracket
Tensioner Eyebolt
Outer
Flywheel
Retainer
Nut
To Next Page
Loading...
