29
19. Installation is the reverse procedure.
PuttheLeftShroudinpositionrsttoalignthescrewsfortheRightShroud.Installthe
topscrewsrst.
NOTICE: This step may require two people. Be sure not to crimp any cables.
Note: Self-tapping screws attach the Shrouds to the Frame.
Be sure the tabs in the Motorized Lift Cover snap into the Side Shrouds.
Installation does not require the use of the crank puller. Be sure the Crank Arms are con-
nected at 180° from each other.
20. Inspect your machine to ensure that all hardware is tight and components are
properly assembled.
Do not use until the machine has been fully assembled and inspected for
correct performance in accordance with the Owner’s Manual.
To Next Page
Loading...
Need help?
General
