11
temperature will be displayed. 30 seconds later，the controller display will be back to
the normal mode.
4. Timer on and off
A. Press set timer on. When the indicator light is on and the time is twinkling,
press again to set hour. Use or to adjust. Before the twinkling stops,
press to set minute.
B. Use or to adjust. After adjusting, press and water temperature
will been seen.
30 seconds later, the controller display will be back to the normal mode.
C. Press to set timer off. When the indicator light is on and the time is
twinkling, press again to set hour. Use or to adjust before twinkling
stop, press to set minute. Use or to adjust. After adjusting, press
and water temperature will been seen. 30 seconds later, the controller display
will be back to the normal mode.
5. Cancel timer on and off
Press or to cancel timer on and off. When the number is twinkling,
press when timer indicator light is off and LED shows water temperature, the
timer on and off is canceled. 30 seconds later, the controller display will be back to the
normal mode.
VII.Testing
1．Inspection before use
A．Check installation of the whole machine and the pipe connections according to the
pipe connecting drawing;
To Next Page
