9
bottom, please pay attention to it. Please hold the drainage nozzle (accessory) into the
hole and clip it well, and then connect a pipe to drain the condensation water out.
B
Wiring
1-Connect to appropriate power supply, the voltage should comply with the rated
voltage of the products. Bond the machine well to earth.
2-Wiring must be handled by a professional technician according to the circuit
diagram.
3-Set GFCI (Ground fault circuit interrupter) protector according to the local code for
wiring (leakage operating current ≤ 30mA).
4-The layout of power cable and signal cable should be orderly and not affecting each
other.
C
Switch on after finishing all wiring construction and re-checking.
VI. Operation Instruction
Picture for keys
To Next Page
Loading...
