EasyManuals Logo

Navico WM-4 User Manual

Navico WM-4
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
WM-4 Marine Weather & Audio Receiver Installation Manual
21
Verify Operation
Power on the system, and the WM-4 Receiver. Verify
that the Power LED light is on (blue), and that the
Network LED light is randomly flashing green, which
indicates normal network traffic.
Consult “Troubleshooting” on page 22 if the
indicator LED lights are not on, or if the Network
LED light is showing a blinking pattern.
Subscribe to SiriusXM Services
You can subscribe to the SiriusXM Marine service
and add satellite Radio at a discount by following
these steps:
1. Make sure the system is turned on. Verify
that you are receiving the SiriusXM signal by
entering the SiriusXM menu in your MFD.
2. Make a note of the Radio ID. You can find it on
a label on the WM-4 Receiver packaging and
on the label on the underside of the WM-4
Receiver.
NOTE! The Radio ID does not use the letters I, O, S, or F.
3. Activate your service:
In the USA:
First see our Customer Agreement for
complete terms at www.siriusxm.com/marine
and then:
Online: Go to www.siriusxm.com/activate
OR
By phone: 1-855-SXM-WTHR (1-855-796-9847)
In Canada:
First see our Customer Agreement for
complete terms at www.siriusxm.ca/marine and
then:
Online: Go to www.siriusxm.ca/activate
OR
By phone: 1-844-823-0843
4. Activation usually takes 10 to 15 minutes, but
may take up to an hour. We recommend that
your MFD remain on until subscribed.
5. Activation signals can be sent again at any time
by visiting www.siriusxm.com/refresh (in USA)
or www.siriusxm.ca/refresh (in Canada).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Navico WM-4 and is the answer not in the manual?

Navico WM-4 Specifications

General IconGeneral
BrandNavico
ModelWM-4
CategoryMarine Equipment
LanguageEnglish