6. Press the Back button ( ) to return to normal operation
mode, or rotate the Command dial (
) to adjust other
operation conditions.
You can adjust the temperature while the display is flashing. Once
the display stops flashing, the current temperature setting is
stored.
Note
●
The default DHW temperature range is 86°F (30°C) to
140°F (60°C).
●
You can adjust the temperature ranges in the
parameter settings menu.
●
The boiler will retain your settings during a power
outage.
4.7.3 Resetting the Boiler
If an error message appears during boiler operation, reset the
boiler to resolve the problem. Press the Back button (
) on the
front panel to reset the boiler.
If resetting the boiler does not solve the problem, refer to the
Troubleshooting section of this manual or contact Technical
Support at 1-800-519-8794.
4.7.2 Adjusting the DHW Temperature
To adjust the water temperature:
1. In normal operation mode, rotate the Command dial (
). The
space heating temperature(
) is highlighted on the screen.
2. Rotate the Command dial ( ) to the right to select the DHW
temperature.
3. Press the Command dial ( ) to select the DHW temperature
( ). The highlighted section will flash.
4. Rotate the Command dial ( ) to the right or left to increase or
decrease the temperature.
5. Press the Command dial (
) to confirm the new temperature.
To Next Page
Loading...
Need help?
General
