Need help?Do you have a question about the Navman iCN 510 and is the answer not in the manual?
General| Display Size | 3.5 inches |
|---|---|
| Resolution | 320 x 240 pixels |
| GPS Receiver | SiRFstar III |
| Removable Memory | SD card slot |
| Voice Guidance | Yes |
| Touchscreen | Yes |
| Display | TFT LCD |
| Battery | Lithium-ion |
Outlines critical safety instructions and user responsibilities for operating the device safely.
Details the physical buttons and indicators on the front of the iCN device.
Identifies and describes the components located on the back of the iCN device.
Details the physical components and ports found on the sides of the iCN device.
Discusses the device's internal battery capacity and charging methods.
Provides instructions on how to charge the iCN's battery using different power sources.
Step-by-step guide on how to properly insert the memory card into the device.
Detailed procedure for powering on the iCN device and its initial setup.
Instructions for properly shutting down or suspending the iCN device.
Explains how to reset the device if it becomes unresponsive or encounters issues.
Provides instructions for installing the device using the suction mount in a vehicle.
Guides users on entering a destination using a street address.
Instructions for defining and adding areas to be avoided on the route.
Explains how to view the calculated route and navigation information on the Map screen.
Details the 3D Map view for route visualization and navigation.
Displays upcoming turn instructions, street names, and distances.
Instructions on how to save destinations as Favourites or Shortcuts.
Configuration options for route calculation preferences.
Setting up audible warnings for exceeding a specified speed limit.
Step-by-step guide for installing the SmartST Desktop software on a PC.
Procedure for installing and activating maps on the iCN using SmartST Desktop.
Guide to installing a basemap for seamless navigation across regions.
Guide to creating a new file for custom Points of Interest.
How to save custom POI files to the iCN device.
To Next Page
