Navman MULTI 100 User Manual

12 NAVMAN M100 User Manual
Backlighting On / Off
Simultaneously press the and keys to
turn the backlight on or off.
LOG
TOTAL
DEPTH
SPEED
AVG
SPEED
DEPTH
LOG
TOTAL
DEPTH
SPEED
AVG
SPEED
DEPTH
Simulation Mode
The NAVMAN M100 has a simulation mode.
To enter this mode, hold down the
key and
then switch on the power. The instrument will
remain in this mode even when power is
switched off.
Repeat this procedure to exit simulation mode.
Note:
Settings that are made while in
simulation mode will remain in effect
after returning to normal mode.
Select Speed/Log Units
Speed and distance units can be selected in the
following order; Knots (nautical miles), kph
(kilometres) and Mph (statute miles).
When the top section of the display is indicating
speed, press and hold the
key for three
seconds. The new unit of measure will be
displayed for three seconds.
Alternatively, when the bottom section of the
display is indicating speed, press and hold the
key for three seconds. The new unit of
measure will be displayed for three seconds.
Note:
When changing speed/distance units, the
log and the totals are re-calculated to show
the same distance in the new units.
Reset Log (Trip Distance)
With the log displayed, press and hold the
and keys for 3 seconds.
Reset Total Log (Total Distance)
With the total log displayed, press and hold the
and keys for 15 seconds.
Note:
When the total log is reset the trip log
log and average speed are reset also.
Reset Average Speed
With average speed displayed, press and hold
the
and keys for 3 seconds.
Reset Max Speed
With max speed displayed, press and hold the
and keys for 3 seconds.
It is possible to display average speed or max
speed and a log value at the same time. In this
situation the LAST function to be selected will be
reset when the
and keys are held down.

Navman MULTI 100 Specifications

General

Brand	Navman
Model	MULTI 100
Category	Measuring Instruments
Language	English