NCR Orderman7 User Manual

Fehler! Kein Text mit angegebener Formatvorlage im Dokument. User Guide V01.06
Operating the Orderman7
Orderman GmbH (Part of NCR Corporation) 39
12.3.2.2 Connecting the belt printer (Bluetooth pairing)
To connect the belt printer to the handheld, proceed as follows:
 Switch on the belt printer.
 Open the Waiter Settings menu
 On the handheld, tap the "Printer Pairing" function in the "Waiter Settings".
 Tap the "Pair Printer now" function.
 Hold the printer close to the handheld (see figure below)
 The antenna used for detecting the printer is located in the upper right corner of the handheld.
The antenna for the printer is located approximately in the center and at the front of the
printer.
 If the printer is detected, the message "State: Paired" is displayed and a test printout is
automatically created.
Fig. 27: Connecting the belt printer
 Belt printer
 Orderman Handheld
 Printer, front
12.3.2.3Testing the belt printer
To test the belt printer, proceed as follows:
 Open the "Settings" menu.
 Tap the "Printer Pairing" field.
 Tap the "Test Print" field (test printout).
 Check the test printout on the belt printer.




NCR Orderman7 Specifications

General

Brand	NCR
Model	Orderman7
Category	Handhelds
Language	English