NCR RealPOS 5967 - Chapter 3: Hardware Installation

3
Chapter 3: Hardware Installation
Introduction
Caution: Thisdeviceshouldonlybepoweredbyapowersupplysourcewhich
meetsSafetyExtraLowVoltage(SELV)andLPS(LimitedPowerSource)
requirementsperUL1950,IEC950,andEN60950.Thepowersourcemustbecertified
bytheappropriatesafetyagencyforthecountryofinstallation.
Caution: Useagroundingstrapwheninstallingthisfeature.
Connector Panel Access
The5967peripheralcableconnectorsarelocatedonthebottomoftheassembly.
VGA
DVI
USB +Power
Audio
USB

Mounting Options
The5967hasaVESAstandard75mmmountingpatternonthebackoftheenclosure.
Theunitisshippedwithmountingscrewsinstalled.