NCR RealPOS 5967 - Re-installing the Touch Sensor

To Next Page

To Previous Page

5-14 Chapter 5: Disassembly Procedures

Re-installing the Touch Sensor

1. InstalltheMoldedBezelSeal.Notethatitisinstalledwiththekeyingtabatthetop

andwiththeridgesinthegasketfacingdown.

303

Keying Tab

Gasket Ridge (Down)



2. InstalltheTouchSensorintheMoldedBezelSeal.NotethattheFlatCableis

connectedtotherearside(inside)oftheTouchSensor.

AfterreplacingtheTouchSensoryoumustperformthecalibrationprocedure.

Related product manuals