NCR RealPOS 5967 - Page 54

6-6 Chapter 6: Touch Screen Calibration - Linux
3. Placeastylusinthecenteroftheflashingtargetinthelowerleft‐handcornerof
thescreenandholdituntilitbeeps.
Note: Forbestresults,astylusshouldbeusedtocalibratethescreenratherthan
yourfinger.Notalloperatorsusethesametouchingtechniquesandcanresultin
poorcali
brationonterminalsthathavemultipleoperators.
24913
Toolkit Calibration
Please Touch The Calibration Symbol (ESC to Abort)

4. Repeatthisprocedurefortheotherthreetargets.
5. SelectOKtocontinue.

6. Testthecalibrationbymovingthestylusaroundonthescreenandverifyingthat
thecursorfollowsit.Also,touchall4Cornersandverifythatthecursormoves
deeplyintothecorners.
7. IfyouaresatisfiedwiththecalibrationresultsselectOKtoexittheTouchKit
Utility.