NDW BC50 User Manual

NDW | We’ll keep you rolling | 24
NDW | We’ll keep you rolling | 25
Lock / Unlock device
While in operation you can lock the controllers to make sure nonauthorized
personnel is not able to change any of the settings. You can do this by
holding the back button for 3 seconds. To unlock the controller again hold
both the back and the OK button for 3 seconds.
Brightness
The brightness setting will change the brightness of the device’s screen.
Hardware info
The device hardware will show information regarding which hardware is in
use, which controller and what version it is. This is not a setting that is able to
be changed, only to be viewed.
Contrast
The contrast setting will change the contrast of the device’s screen.
Software info
The device software will show information about which software is in use, this
can dier per revision. This is not a setting that is able to be changed, only to
be viewed.
Screensaver
The screensaver time of the device will change after how many seconds the
device will show the information screen after not being used or being idle.
Factory reset
The factory reset will reset every setting of the device back to the initial
settings that were set on the device when leaving the factory.
OK
Motor info
0.50 m/s
Hold 3 secondsHold 3 seconds
OK
Motor info
0.50 m/s
Hold 3 seconds
Lock:
Unlock:
Beware of the risk of injuries while cleaning or performing maintenance on
the BC50 controller. Only authorized and qualified personnel is allowed to
perform these kinds of tasks. Make sure that the power is switched o and
cannot be accidentally switched on again during cleaning or maintenance.
Also make sure to indicate cleaning or maintenance work is in progress on-
site to inform co-workers.
Cleaning
In order to avoid potential damage, the BC50 controller should be
periodically cleaned with a vacuum cleaner or dry cloth. Wet cleaning
methods are not allowed. This could cause unrepairable damage to the
controller.
Maintenance
The BC50 controller itself does not require maintenance. It is however
advised to periodically check whether screws, mounts and cables are still
correctly and tightly positioned. Also check whether cables are still correctly
connected to the product’s connectors and if cables have not suered any
visible damage.
In case a BC50 controller is damaged and does not function properly it has to
be replaced. Consult the “Removal” section and “Disposal” section (page 25)
to properly discard the broken product, and the “Assembly” section (page 11)
for re-installing a new BC50 controller. Never try to open a controller.
CLEANING AND MAINTENANCE

NDW BC50 Specifications

General

Brand	NDW
Model	BC50
Category	Controller
Language	English