NDW BC50 User Manual

NDW | We’ll keep you rolling | 10
NDW | We’ll keep you rolling | 11
TRANSPORT AND STORAGE ASSEMBLY
Transport Warning notice concerning assembly
and electrical installation
Not following the safety instructions might lead to failure or shortened
lifetime of the BC50 controller.
Ambient conditions for Storage
Permissible ambient temperature -20 �C to 60 �C
Permissible relative humidity 5% to 95%, non-condensing
Permissible ambient temperature -20 �C to 60 �C
Permissible relative humidity 5% to 95%, non-condensing
Each BC50 motor controller is separately packaged in a cardboard box.
The transport of the controller must be executed by qualified personnel
only. A risk of injury persists when transporting the product incorrectly. The
instructions below must always be followed during transport:
• Not more than four boxes may be stacked on top of each other. This is due
to the risk of tipping over stacked boxes, potentially resulting in a
damaged product.
• Before transportation, make sure that each box is properly fixed.
• Every package should be checked for damage and completeness according
to the “Scope of Delivery” (page 8).
• Impacts on the product must be avoided at all times.
• If any damage occurred during transportation, you are advised to take
photos that will serve as evidence. Immediately report the damage to
the transport company and NDW otherwise compensation cannot
be guaranteed.
• Prevent significant temperature fluctuations while transporting the BC50
controller, since this may lead to condensation, causing serious damage
to the product.
Safety instructions
• Do not drop or otherwise physically mishandle the controller to avoid
internal damage.
• Before assembly check each controller visually for damage.
• Only qualified and authorized personnel should perform electrical work.
• Before installing or making any changes to the wiring of the controller
disable and disconnect the power supply.
• Make sure that the connections and the housing never come in contact with
any hazardous voltages, not even during the malfunction of a controller.
• Do not connect AC current to the E-roller or the controller at any time, as
this will cause irreparable damage to the device.
• The motor plug should be handled with care. Applying too much tension
or load could potentially damage the cable which could lead to failure of
the E-roller.
• Make sure that there is no interference between any existing electrical
installation and the controller or E-roller.
• Make sure that all cables used are the right dimensions for the application.
• Ensure that the power supply unit delivers a nominal DC voltage of 24 V
to the controller.
• Both the E-roller, the controller and the voltage source should be connected
to a conveyor frame or supporting structure in such a way that they
are properly earthed. Earthing incorrectly could potentially result in the
build-up of static charge, causing both the E-roller and the controller to
malfunction.
• Only use the specified connectors.
• Only when all cables have been connected the operating voltage should
be applied.
While storing the BC50 controllers, ensure no more than four boxes are
stacked on top of each other, as this may result in tipping over and possibly
damaging the product. When a controller is taken out of storage, please
inspect for damage prior to usage.

NDW BC50 Specifications

General

Brand	NDW
Model	BC50
Category	Controller
Language	English