DS2000 03.20.07 Release Notes
New Features in 03.20.07
2
◆
03.20.07
DS2000 Release Notes
Automatic Call Screening
With Automatic Call Screening enabled, an extension will immediately screen (broadcast) an
incoming message as soon as the caller starts to leave it in the extension’s mailbox. The extension
user hears two beeps followed by the caller’s voice.
MW LED Operation Change
With the introduction of Call Screening, only the Ring/Message Lamp flashes for new messages.
The
MW
LED is used for Call Screening only.
Note that if more than one caller is leaving a message in a mailbox simultaneously, Call Screening
will listen to the first message.
Programming
0101-Call Screening
Enter
Y
to enable Call Screening. By default, this option is disabled (
N
).
Operation
Manual Call Screening Operation
When Automatic Call Screening is off, you hear a single beep and
MW
flashes fast
while IntraMail records your caller’s message. Your telephone display automatically
changes to show the Call Screening soft key options.
Call Screening is only available while your telephone is idle.
To intercept the call (and stop recording the message):
●
Press
ANSWER
(
ANSW
) or flashing
MW
.
To hear your caller’s message as it is recorded in your mailbox (i.e., activate the Call
Screening mode):
●
Press
SCREEN
(
SCRN
).
-T
o intercept the call (and stop recording the message):
Press
ANSWER
(
ANSW
), or
Press
SPK
, or
Lift the handset, or
Press
MW
.
-To continue listening to your caller’s message as it is being recorded:
Do nothing.
-T
o exit Call Screening and allow the message to continue recording in private:
Press
EXIT
.
-To use another feature or process another call:
Press any other feature key.
To exit Call Screening and allow the message to continue being recorded in private:
●
Press
EXIT
.
To use another feature or process another call:
●
Lift the handset, or
●
Press
SPK
, or
●
Press any other feature key.
Call Screening is only functional while the telephone is on-hook.
To Next Page
Loading...
Need help?
General
