To Next Page

To Previous Page

DS2000 03.20.09/03.21.00 Release Notes

Software Corrections in 03.20.09/03.21.00

DS2000 Release Notes 33 ◆ 03.20.09/03.21.00

Software Corrections in 03.20.09/03.21.00

Caller ID

ANI/DNIS Entry Disables Caller ID

In software versions prior to 03.20.09/03.21.00, making an entry in 1001-ANI/DNIS for a non-T1

trunk would disable Caller ID. This occurred in both DS1000 and DS2000. In software version

03.20.09/03.21.00, the entry for 1001-ANI/DNIS is ignored for non-T1 trunks and will not disable

Caller ID for those types of trunks.

Handsfree and Handsfree Answerback

RING Soft Key Intermittent Operation

Software version 03.20.09/03.21.00 corrects the intermittent operation of the RING soft key in soft-

ware version 03.20.07. After a keyset user placed a voice-announced Intercom call to another key-

set in version 03.20.07, pressing the

RING soft key did not always initiate Forced Intercom Ringing

(i.e., Intercom ringing).

IntraMail

Digital Pager Dialing Delay Fixed at 30 Seconds

The delay that occurs before IntraMail dials the Digital Pager Callback Number is determined by

the setting of 8004-Delay in Dialing Digital Pager Callback Number. In software version

03.20.07, the delay was ﬁxed at 30 seconds, regardless of the setting of this option. This is cor-

rected in version 03.20.09/03.21.00.

EG From Admin Mailbox Doesn’t Erase All Greetings

The System Administrator can use the Subscriber Maintenance EG (34) option to simultaneously

erase all recorded greetings in a subscriber mailbox. Additionally, the active greeting is reset to 1.

In software version 03.20.07, the

EG option only erased the active greeting. This is corrected in

version 03.20.09/03.21.00.

Memory Corruption Problem When IntraMail Installed

Installing IntraMail in software version 03.20.07 could potentially cause a system memory corrup-

tion problem. Although unlikely, it could cause symptoms such as system resets after the installa-

tion of certain PCBs. This is corrected in software version 03.20.09.

Pressing # Doesn’t Complete Message On Hold Recording

After the System Administrator records a Message on Hold (and presses DONE or dials # to com-

plete the recording), they can exit the Message on Hold feature by dialing #, pressing

EXIT, or

hanging up. In software version 03.20.07, hanging up would cause the message to not be recorded.

This is ﬁxed in software version 03.20.09/03.21.00.

NEC DS2000 Release Notes

Other manuals for NEC DS2000