NEC DT510 - Page 13

7
(4) Press Speaker to hang up.
Changing your Extension Incoming Ring Tone
(1) Press Speaker and dial 720.
(2) Dial 1 to set Intercom ring; Dial 2 to set Trunk
ring.
(3) Dial 1 to set the Tone; Dial 2 to set the Melody.
The display below shows when INT is selected
and Program 15-02-78 is enabled
(4) The following is displayed when 2: Melody is
selected.
Displayed when ring tone setting is completed
and ring tone is played.
(5) Press Speaker to hang up.
Listening to the Incoming Ring Choices
(1) Press Speaker and dial 711.
(2) Dial 1 to listen to Intercom ring; Dial 2 to listen to
Trunk ring.
(3) For Intercom Ring:
Dial the code for the ring pattern you want to hear
if Program 15-02-78 is enabled
(Tone:1, Melody:2).
-OR-
1: INT 2: EXT
SET INCOM RING
TONE:1 MELODY:2
SET INT INCOM RING
SET INT INCOM RING
MELODY: 1-5
Tone Type Tone No. Tone Range
Tone:1
1 High
2 Medium
3 Low
Melody: 2
4 Melody 1
5 Melody 2
6 Melody 3
7 Melody 4
8 Melody 5
SETTING COMPLETE
SET INT INCOM RING