6
Terminal Setup With the Feature
Key
Microphone On/Off
LED on Mic key shows the status of the built-in
microphone.
(1) Press Mic.
To Select Ringer Tone
(1) Press Speaker and dial 720.
(2) Dial 1 to set Intercom ring; Dial 2 to set Trunk
ring.
(3) Dial code for the desired ring pattern (1~8).
Display below shows when INT is selected.
(4) Press Speaker to hang up.
Listening to the Incoming Ring Choices
(1) Press Speaker and dial 711.
(2) Dial 1 to listen to Intercom ring; Dial 2 to listen to
Trunk ring.
(3) For Intercom Ring:
Dial the code for the ring pattern you want to hear
(1-8).
-OR-
For Trunk Ring:
Dial code for the ring pattern you want to hear
(Ring1-3, Melody 4-8). If you select Ring 1-3, a second
screen prompts for the tone pattern (1-4).
1: INT 2: EXT
SET INCOM RING
INCOM RING 1-8:?
SET INT INCOM RING
Tone No. Tone Range
1 High
2 Mid Range
3 Low
4 Ring Tone 1
5 Ring Tone 2
6 Ring Tone 3
7 Ring Tone 4
8 Ring Tone 5
Tone No. Tone Range
1 Ring Tone 1
2 Ring Tone 2
3 Ring Tone 3
4 Melody 4
5 Melody 5
6 Melody 6
7 Melody 7
8 Melody 8
To Next Page
Loading...
