NEC DT700 Series - Manual Intercom; Dial Intercom; Dial by Name Using System Speed Dialing

32
Manual Intercom
To Initiate:
 Lift handset or press Speaker key, press MICM key,
ring back tone is heard.
Called party
ICM 2000
4:26 PM TUE 12 FEB 2008
 Each press of MICM key sends tone bursts.
To Answer:
MICM key flashes, indicating an incoming call. Ring tone
may also be heard.
Calling party
ICM 2001
4:26 PM TUE 12 FEB 2008
 Press MICM key.
 Lift handset or press Speaker key, LED lights solid
green.
 If called station is engaged in a non-intercom call, the
station may press MICM key after placing original
caller on hold (with Hold key).
Dial Intercom
To Initiate:
 Lift handset or press Speaker key.
 Press DICM key.
 Dial desired intercom station number (0-9). Tone
burst is sent. (Press 1 to change to ring tone signal.
To Answer:
 DICM LED flashes, indicating an incoming intercom
call. Tone burst or ring tone is heard.
 Press DICM key.
 Lift handset or press Speaker. LCD shows solid
green.
Dial By Name Using System Speed Dialing
To Initiate:
 Press the SYS soft key.
 Enter up to the first four characters of a name using
the keypad.
 Press the UP or DOWN key to start the search.
 The name and the number are shown on the LCD. If
more than one name matches the letters entered,
scroll through the matches with the UP or DOWN soft
key.
 If no matches are founds, the first System Speed Dial
buffer will be displayed.
 Press the Speaker key, or selecting a Line/Trunk key
to dial the selected number.