14 Express5800/320La System Release Notes
Add the following Warning to this section:
CIRCUIT OVERLOADING: Consider the current drain of
equipment connected to the supply circuit and the effect of
overloading of circuits might have on overcurrent protection and
supply wiring. Refer to equipment nameplates for power and current
ratings.
Replace the “Temperature Caution” text with the following text:
!
CAUTION
Temperature: If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of the
rack environment may be greater than the room
ambient temperature. The operating temperature of the
server unit, when installed in an equipment rack, must
not go below 5 °C (41 °F) or rise above 35 °C (95 °F).
Extreme fluctuations in temperature can cause a variety
of problems in your server. It is recommended that the
ambient temperature for a rack-mount unit not exceed
25°C.
! Chapter 4
Pages 4-23, 4-25, 4-26, and 4-27 - Change “Fan #1” references to
“Fan A.”
Page 4-25, Step 3 – Change “See Figure 4-24” to “See Figure 4-29.”
Page 4-26, Step 4 – Change “See Figure 4-25” to “See Figure 4-30.”
Page 4-26, Step 5 – Change “See Figure 4-26” to “See Figure 4-31.”
Page 4-26, Step 9 – Change “See Figure 4-28” to “See Figure 4-32.”
Page 4-33, Step 4 – Change “See Figure 4-40” to “See Figure 4-41.”
Page 4-38, Step 4 – Add “See Figure 4-49.”
Page 4-47, - Change “Step 2” to “Step 3.”
Page 4-62, Step 9 – Add “See Figure 4-76.”