Express5800/320La System Release Notes 7
Documentation Errata
Express5800/ft Series EXPRESSBUILDER User’s Guide
Please note the following corrections to the Express5800/ft Series
EXPRESSBUILDER User’s Guide, 456-01574-001.
Chapter 2 – Initial Setup
Initial Setup procedures have changed. Use the following procedures for
performing "Initial Setup" before performing the Windows 2000 Advanced
Server installation.
Note: If Windows 2000 Advanced Server is preloaded
on your system, you do not need to perform these Initial
Setup Procedures.
Initial Setup
Perform the initial setup procedures before performing the Windows 2000
Advanced Server installation. Initial setup will perform the following functions.
! Enable the greater than 4Gbyte disc geometry in each PCI module
! Change the system BIOS setting to disable Boot Monitoring.
1. Power down the server.
2. Ensure the mouse, keyboard and monitor are connected to the server.
3. Disconnect PCI module 1 from the system backplane.
! Unlock and open the front door on the tower cabinet or front covers on
the rack-mount system. Refer to Chapter 4 of your System User’s Guide
for information on opening the system front door or system front covers.
! Unscrew the knurled screw securing the locking handle to the PCI
module 1. See Figure 2-1.
To Next Page
Loading...
Need help?
General
