4 Express5800/320La System Release Notes
TCP/IP Protocol Settings for Windows 2000
If you have computers that communicate with the NEC EXPRESS5800/ft server
using TCP/IP protocols, you must make several settings to your ft server to
allow communications without interruptions. These setting changes must also be
made in all clients connected to the EXPRESS5800/ft server via the network.
Note: If Windows 2000 Advanced Server is preloaded
on your system, you do not need to perform this procedure
on your ft server. However, this procedure should be
performed on all computers connected to your ft server.
1. Power up the server and its peripherals.
2. Insert the EXPRESSBUILDER CD disk in the CD-ROM drive. Immediately
press and hold down the Shift key to prevent auto start.
3. In Windows Explorer or My Computer, locate the CD-ROM drive (labeled
2001 ag) containing the EXPRESSBUILDER CD disk.
! Locate the WinNT folder and double click on it.
! Double click on W2K.
! In the W2K folder, find and copy Ftreg.exe into an arbitrary directory
on your hard drive.
4. Activate the command prompt, enter the directory containing the above file
copy, and then execute the following command:
FTREG.EXE
Executing FTREG.EXE makes changes to your system registry to avoid a
timeout during initial communications between the NEC EXPRESS5800/ft
server and computers on the network using TCP/IP protocols.
Disk Failure Prediction (S.M.A.R.T)
Disk failure prediction S.M.A.R.T (Self-Monitoring Analysis and Reporting
Technology) is not supported. When running the ft Server Utility, do not enable
“Disk Failure Prediction (S.M.A.R.T.).”
SCSI Controller Errors
During a tape backup, the Event Log may record an erroneous sraql180 SCSI
controller error. The error description is “the driver detected a controller error
on \Device\SCSI\sraq1801. If the detailed data includes word “f0030015,”
ignore this error as the tape backup is functioning normally.
To Next Page
Loading...
Need help?
General
