NEC LT280 - Part Names of the Projector

4
1. Introduction
 Part Names of the Projector
P
C
C
A
R
D
L
A
M
P
S
T
A
T
U
S
P
O
W
E
R
S
O
U
R
C
E
A
U
T
O
A
D
JU
S
T
3
D
R
E
F
O
R
M
O
N
/
S
T
A
N
D
B
Y
SE
LE
C
T
Controls
( → page 6)
Built-in Security Slot ( )*
Ventilation (inlet)
Lens
Lens Cap
Adjustable Tilt Foot
( → page 27)
Remote Sensor
(
→ page 9)
Focus Ring
( → page 28)
Zoom Lever
(
→ page 28)
Adjustable Tilt Foot Lever
(
→ page 27)
* This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of Kensington
Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.
Carrying the Projector
Always carry your projector by the handle.
Ensure that the power cable and any other cables connecting to video sources are disconnected before moving the
projector.
When moving the projector or when it is not in use, cover the lens with the lens cap.
Ventilation (inlet)
Adjustable Tilt Foot
( → page 27)
Carrying Handle
Front/Top
Filter
NOTE: To stand the projector on its end, do so by holding the cabinet, not by holding the carrying handle.
Doing so can cause damage to the carrying handle.