NEC LT280 - [Video]

75
6. Using On-Screen Menu
[Video]
Turning On/Off 3 Dimension Separation [3D Y/C Separation]
This function turns on or off the 3 dimensional separation feature.
Off ............................... Turns off the function.
On Still ................. Recommended for a still image.
Normal ............ The projector detects and corrects the image automatically.
Movie .............. Recommended for a moving image.
TIP: When the image is poor quality, turn on [3D Y/C Separate]. If there is still poor quality, try turning off [Deinterlace] or try turning
off [3D Y/C Separate] and select [Normal] in [Deinterlace].
NOTE: This feature is available for NTSC3.58 of Video signal only.
Setting Vertical Edges [Vertical Enhancer]
This function enhances the vertical edges around objects in the image.
NOTE: This function is not available for an RGB, HDTV and Component signal.
Selecting Interlace or Deinterlace [Deinterlace]
This function allows you to select between "Interlace" and "Deinterlace".
Off ............................... Project the interlaced signal.
On Still ................. Select when a still image is displayed. When this option is selected for a moving image, jitter or artifacts
can be seen.
Normal ............ The projector automatically determines a still or moving image to display a clear picture. If selecting
[Normal] causes excess jitter or artifacts, select [Movie].
Movie .............. Select when a moving image is displayed. This will eliminate jitter and artifacts in a moving image. This
option is available only for SDTV.
Setting Telecine Mode [Telecine]
Use 3:2 pull down correction to eliminate jitter and artifacts in video.
NOTE: This feature is available only when [Deinterlace] is turned on and an SDTV signal is selected.
Off ..................................... Turns off the Telecine mode.
On 2-2/2-3 Auto ......... Detects pull-down correction method.
2-2 On .................. Uses 2-2 pull-down correction method
2-3 On .................. Uses 2-3 pull-down correction method