NEC M362W - Turning Off the Projector

29
2. Projecting an Image (Basic Operation)
❾ Turning off the Projector
Toturnofftheprojector:
1. First, press the (POWER) button on the projector
cabinet or the STANDBY button on the remote con-
trol.
The confirmation message will be displayed.
2. Secondly, press the ENTER button or press the
(POWER)ortheSTANDBYbuttonagain.
 Aftertheprojectorturnsoff,thecoolingfanskeepoperating
for a while (Cooling-off time).
The cooling fans stop operating when the projector turns
off and goes into standby mode. When in standby mode,
the POWER indicator will light red and the STATUS indica-
tor will light off when [NORMAL] is selected for [STANDBY
MODE].
PowerOn
Steady blue light
Standby
Steady
red light
CAUTION:
PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbuttonorifthe
ACpowersupplyisdisconnectedduringnormalprojectoroperation.
Usecautionwhenpickinguptheprojector.
NOTE:
• Whilethepowerindicatorisblinkingblueinshortcycles,thepowercannotbeturnedoff.
• Youcannotturnoffthepowerfor60secondsimmediatelyafterturningitonanddisplayinganimage.
• DonotdisconnecttheACpowersupplytotheprojectorwithin10secondsofmakingadjustmentorsettingchangesandclosing
themenu.Doingsocancauselossofadjustmentsandsettings.