NEC ME401W - ❷ Connecting Your Computer;Connecting The Power Cord

11
2. Projecting an Image (Basic Operation)
❷ Connecting Your Computer/Connecting the Power Cord
1. Connectyourcomputertotheprojector.
This section will show you a basic connection to a computer. For information about other connections, see “6.
InstallationandConnections”onpage90.
 Connectthecomputercable(VGA)betweentheprojector’sCOMPUTERINterminalandthecomputer’sport
(mini D-Sub 15 Pin). Turn two thumb screws of both terminals to x the computer cable (VGA).
2. Connectthesuppliedpowercordtotheprojector.
 Firstconnectthesuppliedpowercord’sthree-pinplugtotheACINoftheprojector,andthenconnecttheother
plug of the supplied power cord in the wall outlet.
The projector’s power indicator will ash for a few seconds and then will light red* (standby mode).
 *Thiswillapplyforbothindicatorswhen[NORMAL]isselectedfor[STANDBYMODE].SeethePowerIndicator
section.(→ page 108)
COMPUTER IN
Makesurethattheprongsarefully
insertedintoboththeACINandthe
wall outlet.
To wall outlet ←
CAUTION:
PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbuttonorifthe
ACpowersupplyisdisconnectedduringnormalprojectoroperation.
Becarefultohandletheprojector.