NEC ME401W - ❻ Menu Descriptions & Functions [Setup]; [General]

67
5. Using On-Screen Menu
❻ Menu Descriptions & Functions [SETUP]
[GENERAL]
EnablingAutoKeystone[AUTOKEYSTONE]
Thisfeatureallowstheprojectortodetectitstiltandcorrectverticaldistortionautomatically.
ToturnontheAUTOKEYSTONEfeature,select[ON].ToadjusttheKEYSTONEfeaturemanually,select[OFF].
NOTE:
• The[AUTOKEYSTONE]functionisnotavailablewhenanorientationtypesuchas[CEILINGREAR],[DESKTOPREAR],[CEILING
FRONT]otherthan[DESKTOP/FRONT]isselectedfor[ORIENTATION].
• Whilethe[AUTOKEYSTONE]is[ON],thefollowingfunctionsarenotavailable,[PINCUSHIONLEFT/RIGHT],[PINCUSHIONTOP/
BOTTOM],and[CORNERSTONE].
TIP
• Adjustableanglerangebythe[AUTOKEYSTONE]isapprox.30degreesinverticaldirection.
• Duringprojectingimage,[AUTOKEYSTONE]willbestartedtoperformapprox.2secondsafterxingthethrowangle.
CorrectingKeystoneDistortionManually[KEYSTONE]
Youcancorrecthorizontalorverticalkeystone,pincushionLEFT/RIGHTorTOP/BOTTOM,orcornerstonedistortion
manually.
NOTE:
• [KEYSTONEHORIZONTAL]and[KEYSTONEVERTICAL]canbeadjustedatonce.
• Tochangefromoneitemtoanotheritem,resettherstitem.
• Adjustmentvalueswillbeoverwritten.Theywillnotbedeletedevenwhentheprojectoristurnedoff.
• Using[KEYSTONE],[PINCUSHION]and[CORNERSTONE]correctioncancausetheimagetobeslightlyblurredbecausethe
correctionismadeelectronically.
• Whenthe[AUTOKEYSTONE]hasbeen[ON].itautomaticallyperformsverticalkeystonecorrectioneverytimetheprojectoris
poweredon.
KEYSTONE HORIZONTAL ��������� Corrects horizontal keystone distortion� (→ page 18)
KEYSTONE VERTICAL
��������������� Corrects vertical keystone distortion� (→ page 18)
PINCUSHION LEFT/RIGHT
�������� Corrects pincushion distortion at the left or right side� (→ page 28)
PINCUSHION TOP/BOTTOM
����� Corrects pincushion distortion at the top or bottom side� (→ page 28)
CORNERSTONE
������������������������ Fits a projected image within the border of the screen easily by align the four corner of an image
to the ones of the screen� (→ page 26)
RESET
��������������������������������������� Returns all the above items to the factory preset values�