NEC ME401W - ❷ Projecting Images Stored In A Usb Memory Device; Starting the Viewer

47
4. Using the Viewer
❷ Projecting images stored in a USB memory device
ThissectionexplainsthebasicoperationoftheViewer.
TheexplanationprovidestheoperationalprocedurewhentheViewertoolbar(→page51)issettothefactorydefault.
-StartingtheViewer .......................................................................below
-RemovingtheUSBmemoryfromtheprojector ....................... page49
-ExitingtheViewer .................................................................... page49
Preparation:BeforestartingtheViewer,storeimagestotheUSBmemoryusingyourcomputer.
Starting the Viewer
1. Turn on the projector. (→ page 12)
2. Insert the USB memory into the USB port of the projec-
tor.
• DonotremovetheUSBmemoryfromtheprojectorwhile
it’s LED ashes. Doing so may corrupt the data.
3. PresstheSOURCEbuttonontheprojectorcabinet.
The Viewer start screen will be displayed.
• PresstheUSB-Abuttonontheremotecontrol.