NEC MultiSync C431 - NULL Message

(20/104)
5.5.3 NULL Message
The NULL message returned from the monitor is used in the following cases;
 To tell the controller that the monitor does not have any answer to give to the host (not
ready or not expected)
 Complete "NULL Message" command packet as follows;
01h-30h-30h-41h-42h-30h-34h-02h-42h-45h-03h-CHK-0Dh
SOH-'0'-'0'-'A'-'B'-'0'-'4'-STX-'B'-'E'-ETX-CHK- CR
STX
Command code
ETX
'B' 'E'