NEC MultiSync C431 - Page 68

NEC MultiSync C431

101 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

(68/104)

ETX (03h): End of Message

Check code

BCC: Block Check Code

Refer to the section 4.3 “ Check code” for a BCC calculation.

Delimiter

CR (0Dh): End of packet

Table of Contents

Default Chapter1
- Table of Contents1
- Application4
2 Connectors and Wiring5
- LAN Control5
- Preparation5
- RS-232C Remote Control5
3 Communication Parameter6
- Communication Specification6
- Communication Timing6
- LAN Control6
- RS-232C Remote Control6
4 Communication Format7
- Header Block Format (Fixed Length)8
- Message Block Format10
- Check Code12
- Delimiter12
- Get Current Parameter from a Monitor13
5 Message Type13
- Get Parameter" Reply14
- Set Parameter16
- Set Parameter" Reply17
- Commands18
- Save Current Settings18
- Get Timing Report and Timing Reply19
- NULL Message20
- Control Commands21
- How to Change the "Backlight" Setting21
6 Typical Procedure Example21
- How to Read the Measurement Value of the Built-In Temperature Sensors24
- Operation Code (OP Code) Table27
7 Power Control Procedure37
- Power Status Read37
- Power Control39
8 Asset Data Read and Write41
- Asset Data Read Request and Reply41
- Asset Data Write42
- Date & Time Read44
9 Date & Time Read and Write44
- Date & Time Write46
- Schedule Read49
10 Schedule Read and Write49
- Schedule Write52
- Holiday Read58
11 Holiday Read and Write58
- Holiday Write60
- Weekend Read63
12 Weekend Read and Write63
- Weekend Write65
13 Self Diagnosis67
- Self-Diagnosis Status Read67
14 Serial No. & Model Name Read69
- Serial No. Read69
- Model Name Read71
15 Security Lock73
- Security Lock Control73
- Daylight Saving Read75
16 Daylight Saving Read & Write75
- Daylight Saving Write77
17 Firmware Version79
- Firmware Version Read79
18 Input Name81
- Input Name Read81
- Input Name Write83
- Input Name Reset85
19 Power Save Mode87
- Power Save Mode Read87
- Power Save Mode Write89
- Auto Power Save Time Read91
- Auto Power Save Time Write92
20 Security Enable93
- Security Enable Read93
- Security Enable Write94
21 LAN MAC Address96
- LAN MAC Address Read96
22 Emergency Contents98
- Emergency Contents Display98
- Emergency Contents Delete100

Related product manuals

Preview: NEC MultiSync C651Q

NEC MultiSync C651Q

Preview: NEC MultiSync CB651Q

NEC MultiSync CB651Q

XP21 - MultiSync - 21" CRT Display

NEC MultiSync V484

Preview: NEC MultiSync V554

NEC MultiSync V554

NEC MultiSync XV15

NEC MultiSync V652

Preview: NEC MultiSync P404

NEC MultiSync P404

NEC MultiSync P701

NEC MultiSync V520

NEC MultiSync V801

Preview: NEC HR17 MultiSync

NEC HR17 MultiSync