NEC MultiSync LT280 - Page 31

31
3
3. Basic Operation of Desktop Control Utility 1.0
Basic Operation of Desktop Control Utility 1.0
2
Input the starting password of Desktop Control Utility 1.0, and click [OK].
The "Current password" window will be displayed.
Note
The character string displayed in the password field varies each time Desktop Control Utility
1.0 is started.
3
Write down the character string displayed in the password field.
Write down "NDKE" in the screen example of step
2
.
4
Click [OK].
Desktop Control Utility 1.0 will be started.
Move to the room where the projector is installed, with the paper on which you have written down the
password in step
3
.
■ Operating the projector (connecting personal computer)
1
Connect a USB mouse that is commercially available to the projector.
PC CARD
COMPONENT IN
USB LAN
AUDIO IN
COMPUTER 3 IN
COMPUTER 1 IN COMPUTER 2 IN
PC CONTROL
MONITOR OUT
AUDIO OUT
S-VIDEO IN VIDEO IN
AUDIO
Cb/Pb
L/MONO R
Y
Cr/Pr
AC IN
USB
2
Turn on the power to the projector.
Set the LAN setting of the projector in advance.