32
3. Basic Operation of Desktop Control Utility 1.0
3
Click the USB mouse.
An on-screen menu will be displayed.
4
Click "Source" and then "LAN".
* The screen of the NP2000/NP1000/LT380
A message screen will be displayed.
This message is not displayed if a password for the Desktop Control is registered.
If this message is not displayed, proceed to step
5
.
5
Press the
button of the projector or remote control.
The connection bar will be displayed at the lower left of the screen.
6
Click (password input icon).
The "Password (Desktop Control)" screen will be displayed.
7
Click "Entry".
A password input screen will be displayed.
To Next Page
Loading...
