Connection to Your Personal Computer
The MultiSync P750 color monitor complements NEC computers, PC
compatibles, Macintosh and Macintosh compatibles.
For the PC:
Your system has one of two configurations:
– the video controller is built into the computer
– the video controller is in the form of a display card (sometimes
referred to as the graphics card, video adapter or graphics board)
Both configurations have a video connector (or a CRT PORT on laptop
computers). If you are not sure which port is the video connector, please
consult your computer or display card manual.
For the Mac:
With the MultiCable, the MultiSync P750 color monitor is compatible
with Macintosh computers, as well as Macintosh clones.
NOTE: Power Macintosh 6100/60 users need to use the Apple HDI-45
cable adapter in conjunction with the MultiCable when connecting a
MultiSync P750.
The MultiSync P750 MultiCable allows you to change between
640 x 480, 832 x 624, 1024 x 768, 1152 x 870 and 1280 x 1024 screen
resolutions without restarting your system, if the video port supports
these modes. You will connect your MultiSync P750 monitor one of
two ways to your Macintosh computer:
– On-board video port
– NuBus, PDS or PCI display card
Both configurations should have the same style video connector. If you
are not sure which port is the video connector, please consult your
computer or display card manual.
Connection to Your Personal Computer E - 9
To Next Page
Loading...
Need help?
General