Problem Check These Items
LED on the monitor is not lit (no
green, orange or yellow color can be
seen)
Power Switch should be in the ON
position and the power cord should
be connected.
Picture is fuzzy: Adjust the Brightness, then Contrast
Controls. Access the Degauss Control
through OSM. Activate the Degauss
Control. CAUTION: A minimum
interval of 20 minutes should exist
before the Degauss Function is used a
second time.
Picture bounces or a waving pattern.
is present in the picture
Move electrical devices that may be
causing electrical interference away
from the monitor.
Edges of the display image are not
square
Use the OSM Geometry Controls to
straighten the edges.
Display image is not centered, too
smaIl, or too large
Use the OSM Size and Position
controls to adjust the image.
Color looks blotchy Adjust the Brightness, then Contrast
Controls. Access the Degauss Control
through OSM. Activate the Degauss
Control. CAUTION: A minimum
interval of 20 minutes should exist
before the Degauss Function is used a
second time.
No green color (if using BNC
connection)
Check the BNC cables for propper
connection (G and CS connection
may be reversed).
E - 20 Troubleshooting/Support
To Next Page
Loading...
