Chapter 2 System Architecture
Page 2- 10 NEAX2000 IPS
Request For Proposal (RFP) Reference Guide
NDA-24349 Issue 4
AC Cord
The AC cord provides a connection between the AC/DC Power Card and Base Unit.
AC Cord
Name Code Qty Remarks
AC CORD-B-U 1/PIM AC power cable (Included in PIM)
AC CORD-D-U 1/BASE AC power cable for BASE (Included in BASE)
External Cabling
IP Connection
MP with PZ-M606-A and IP PAD
Name Code Qty Remarks
IP TRK BUS CA 1/VCT IP TRK BUS Cable 0.1m (0.33ft)
(Included in SPN-16VCTA IP PAD)
IP Trunk (H.323, CCIS over IP w/IVS2)
Name Code Qty Remarks
IP TRK BUS CA 1/VCT IP TRK BUS Cable 0.1m (0.33ft)
(Included in SPN-4VCTI-A, or
SPN-4VCTI-B.)
Maintenance Administration Terminal (MAT) (RS-232C)
Direct Connection
MAT Cable (Direct)
Name Code Qty Remarks
MAT CA-T 1/MAT RS-232C cable, 2m (6.6ft.)
MAT CA-P 1/MAT RS-232C cable, 4m (13.1ft.)
Remote connection
Remote connection is available via an internal modem in the MP or an external modem.
MAT Cable
Name Code Qty Remarks
RS NORM-4S CA-A 1/MAT RS-232C cable, 4m (13.1ft.)
Built-in SMDR/MCI on MP
The MP card provides RS-232C interface ports for SMDR/MCI connection.
No. 0/1 Port: Async. : 1200/2400/4800/9600/19200 bps
To Next Page
Loading...
