NEC NEAX 7400 ICS M100MX - Page 628

FEATURES FOR OTHER COUNTRIES ONLY
MFC-INCOMING CALL/MFC-OUTGOING CALL
– 608 –
A2594-10
(2) DID Data Assignment
DESCRIPTION DATA
Assign the MFC Signaling to required DID
trunk route.
•
(1)
(2)
Y=37
00-63: Trunk Route No.
0: Available
Assign the number of received digits of
ANI signal from PSTN.
NOTE: CM31 Y=1>3 setting is required
when CM08>472 is assigned to
0.
•
(1)
(2)
Y=1
3
01-31: 1 digit-31 digits
NONE
Assign the sending Backward GA signals
depending on the specification of each
country.
•
(1)
(2)
Y=3: Backward GA
00-15
01-15
NONE
Assign the sending Backward GB signals
depending on the specification of each
country.
•
(1)
(2)
Y=4: Backward GB
00-15
01-15
NONE
Assign the sending Backward GC signals
(For Mexico only).
•
(1)
(2)
Y=5: Backward GC
00-15
01-15
NONE
Assign the Pulse Form/Pulse Type-1/
Pulse Type-2 signals.
NOTE 1: In Malaysia and Poland, no data
setting is required.
NOTE 2: For details of Pulse Form/Pulse
Type-1/Pulse Type-2 signals, re-
fer to the Command Manual.
•
(1)
(2)
Y=A
05: Pulse Form signal
06: Pulse Type-1 signal
07: Pulse Type-2 signal
01-15
NONE
NOTE 3:
Refer to the “MFC Data Assign-
ment Table for Each Country”.
page 615
CM31
START
CM35
A
INITIAL
INITIAL
NOTE 3
INITIAL
INITIAL
INITIAL