19
1. What’s in the Box? and the Names of the Projector Parts
1-3. Names of the Projector Parts
1-3-1. Front of the projector
1
2
9
10
11
3
4
5
7
8
6
1. LIGHT status indicator
Displays the status of the light source. The indicators turn on when the light source is on and turn off when the light source
is off (See page 62).
2. SYSTEM status indicator
These indicate the status of the projector. When the projector is operating normally, these light/blink in green or orange.
When an error occurs, they light/blink in red. When an error occurs, check the contents of the display on the LCD screen.
(See page 62)
3. Main power switch
While AC power is being supplied, set the main power switch to ON position (1), then your projector will enter a standby
state.
4. AC input
Connects to the AC power cable. The AC power cable is not an accessory. Consult with your dealer/distributor about the
AC power cable.
5. Power cable stopper
Prevents the power plug from falling out from the projector.
6. Switch for administrator
The projector can be operated normally by inserting the administrator key vertically and turning it to the horizontal direction.
At this time, the administrator key cannot be removed. The projector will not function unless the administrator key is
inserted.
7. Control panel
On the control panel, power to your projector is turned on or off, titles are selected, and various adjustments are made of
projected screen. (See page 24)
To Next Page
Loading...
