NEC NP-17CU01 - Table of Adjustment Menus

52
4. Using Menus
4-4-3. Reset
This is used to reset the light and air filter usage times.
Filter Cleaning
Resets the air filter usage time (for confirming the filter cleaning time).
[1] Press the ENTER button, the confirmation screen will appear.
[2] Select “Yes” in the confirmation screen, and then press the ENTER button to reset the filter usage time.
← Press the ENTER button to display the confirmation screen.
4-4-4. Installation
Lens Type
Sets the type of lens (supports or does not support the lens memory function) attached to the projector. This menu item is
available only when you are logged into the projector with Advanced User or higher privileges.
←Displaysthecurrentlyselecteditemwithasterisk(*).
← Displays the setting.
Without Sensor Selected when using a lens unit that does not support the lens memory function (default value).
With Sensor Selected when using a lens unit that supports the lens memory function.
Lens Calibrate
Performs calibration on lenses that support the lens memory function. Once you have attached a lens that supports the lens
memory function, always execute calibration. This menu item is available only when the projector power is turned on and you
are logged into the projector with Advanced User or higher privileges.
NOTE
This items cannot be used if Lens Type is set to “Without Sensor”.
← Press the ENTER button to execute calibration.
Lens Center
To move the lens shift to the center position. The center position may slightly shift depending upon mounting conditions of the
lens. This menu item is available only when the projector power is turned on and you are logged into the projector with
Advanced User or higher privileges.
← Press the ENTER button to execute moving.