38
3. Projection of Images (Basic Operation)
3-3. Selecting the title of input signal
This projector allows you to select pre-registered title (input signal) using the preset buttons on the control panel (up to 16 titles).
Request your dealer/distributor for details on registering and changing titles. This section explains the steps for selecting registered
titles.
Turn on the power to the image devices connected to the projector.
Press the MENU button.
Press the LEFT/RIGHT button to display “Title Select” on the LCD screen.
At each press of the LEFT/RIGHT buttons, the display will cycle as “Title Select” ←→ “Configuration” ←→ “(Title Setup)”
←→ “Information.”
Press the DOWN button.
The title of the input signal is displayed.
• When you have made a wrong selection, press the UP button. A return will be made to the previous menu.
Press the LEFT/RIGHT buttons to display “Title of Signal to be Projected” on the LCD screen.
Press the ENTER button.
The title of the signal to be projected is selected.
• The (*) mark on the LCD indicates that this is the currently selected item.
To Next Page
Loading...
Need help?
General
