30
2. Installation and Connection
Slide the clamper to the hilt of the power cable.
This completes the attachment of the power cable stopper.
Removing the power cable from the power cable stopper
Push the clamper of the power cable stopper to unclasp it.
knob
Push the power cable clamper to open it wide enough to pull out the power cable.
knob
clamper
CAUTION
The projector may become hot temporarily when the power is turned off or if the AC power is disconnected while the projec-
tor is projecting. Take care when handling the projector.
To Next Page
Loading...
