EasyManuals Logo

NEC NP-V260 User Manual

NEC NP-V260
107 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
2
1. Introduction
Introduction to the Projector
This section introduces you to your new projector and describes the features and controls.
Congratulations on Your Purchase of the Projector
This DLP
®
projector is one of the very best projectors available today. The projector enables you to project precise
images up to 300 inches (measured diagonally) from your PC or Macintosh computer (desktop or notebook), VCR,
DVD player or document camera.
You can use the projector on a tabletop or cart, you can use the projector to project images from behind the screen,
and the projector can be permanently mounted on a ceiling*1. The remote control can be used wirelessly.
*1 Do not attempt to mount the projector on a ceiling yourself.
The projector must be installed by qualified technicians in order to ensure proper operation and reduce the risk of bodily
injury.
In addition, the ceiling must be strong enough to support the projector and the installation must be in accordance with any
local building codes. Please consult your dealer for more information.
Features you'll enjoy:
Quick start & Quick Power Off
7 seconds after turning on the power, the projector is ready to display PC or video images.
The projector can be put away immediately after the projector is powered down. No cool down period is required
after the projector is turned off from the remote control or cabinet control panel.
Direct Power Off
The projector has a feature called “Direct Power Off”. This feature allows the projector to be turned off (even when
projecting an image) by disconnecting the AC power supply.
To turn off the AC power supply when the projector is powered on, use a power strip equipped with a switch and
a breaker.
Less than 1W in standby condition with energy saving technology
Selecting [POWER-SAVING] for [STANDBY MODE] from the menu can put the projector in power-saving mode
that consumes only 0.49W (100-130V AC)/0.71W (200-240V AC).
Carbon Meter
This feature will show energy-saving effect in terms of CO
2
emission reduction (kg) and electricity cost when the
projector’s [ECO MODE] is set to [ON].
The amount of CO
2
emission reduction will be displayed in the confirmation message at the time of power-off and
in the INFO of the on-screen menu.
7W built-in speaker for an integrated audio solution
Powerful 7 watt speaker provides volume need for large rooms.
HDMI input port provides digital signal (V300X/V260X/V300W/V260W only)
The HDMI input provides HDCP compatible digital signals. The HDMI input also supports audio signal.
Two computer inputs provided (V300X/V260X/V300W/V260W only)
The V300X/V260X/V300W/V260W projector comes with two computer input ports (Mini D-Sub15P) with audio
inputs (two stereo mini jacks) as well as composite and S-video inputs with audio inputs (a pair of L/R RCA jacks).
DLP
®
projector with high resolution and high brightness
High resolution display - up to UXGA compatible, XGA (V300X/V260X/V230X)/ SVGA (V260/V230)/ WXGA(V300W/
V260W) native resolution.

Table of Contents

Other manuals for NEC NP-V260

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC NP-V260 and is the answer not in the manual?

NEC NP-V260 Specifications

General IconGeneral
Native aspect ratio4:3
Projection distance1.2 - 13 m
Vertical scan range50 - 120 Hz
Horizontal scan range15 - 100 kHz
Projection technologyDLP
Contrast ratio (typical)2000:1
Screen size compatibility33 - 300 \
Projector native resolutionSVGA (800x600)
Keystone correction, vertical-40 - 40 °
FocusManual
Throw ratio1.95 - 2.15:1
Zoom capabilityYes
Focal length range21.83 - 24 mm
RS-232 ports1
Maximum analog resolution1920 x 1080 pixels
Lamp typeAC HID
Lamp power180 W
Light source typeLamp
Service life of light source3500 h
Service life of light source (economic mode)5000 h
DVI portNo
Serial interface typeRS-232
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Component video (YPbPr/YCbCr) in0
Supported video modes1080i, 480p, 576i, 576p, 720p
Analog signal format systemNTSC 4.43, PAL, PAL L, PAL M, SECAM
Supported graphics resolutions1024 x 768 (XGA), 1280 x 1024 (SXGA), 1360 x 768 (WXGA), 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 1600 x 1200 (UXGA), 800 x 600 (SVGA)
RMS rated power7 W
PlacementCeiling
Product typeStandard throw projector
Product colorWhite
Power sourceAC
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (max)233 W
Power consumption (standby)4 W
Power consumption (PowerSave)0.5 W
Power consumption (economy mode)210 W
Noise level34 dB
CertificationCE; ErP; ÜV GS
Noise level (economic mode)31 dB
Storage temperature (T-T)-20 - 50 °C
Operating temperature (T-T)5 - 40 °C
Cables includedAC, VGA
Remote control typeIR
Sustainability certificatesRoHS
Weight and Dimensions IconWeight and Dimensions
Depth247 mm
Width310 mm
Height95 mm
Weight2500 g

Related product manuals