NEC NP-V260 - Changing Eco Mode

32
4. Convenient Features
 Changing Eco Mode
This feature enables you to select two brightness modes of the lamp:
OFF and ON modes. The lamp life can be extended by turning on the [ECO MODE].
[ECO MODE] Description Status of LAMP indicator
[OFF] This is the default setting (100% Brightness). Off
STATUS
LAMP
[ON] Select this mode to increase the lamp life (approx.
90% Brightness on V260X/V230X/V260/V230/
V260W and approx.75% Brightness on V300X/
V300W.)
Steady Green light
STATUS
LAMP
To turn on the [ECO MODE], do the following:
1. Press the ECO button on the remote control to display [ECO
MODE] screen.
2. Use the  or  button to select [ON].
3. Press the ENTER button.
To change from [ON] to [OFF], Go back to Step 2 and select [OFF].
Repeat Step 3.
NOTE:
• The [ECO MODE] can be changed by using the menu.
Select [SETUP] → [GENERAL] → [ECO MODE].
• The lamp life remaining and lamp hours used can be checked in [USAGE TIME].
Select [INFO.] →[USAGE TIME].
• The projector will always enter into the [ECO MODE] [ON] condition for 90
seconds immediately after the projector is turned on. The lamp condition will
not be affected even when [ECO MODE] is changed within this time period.
• After a lapse of 45 seconds from when the projector displays a blue, black or
logo screen, [ECO MODE] will automatically switch to [ON]. This is done only
when [ECO MODE] is set to [OFF].
• If the projector is overheated in [OFF] mode, there may be a case where the [ECO
MODE] automatically changes to [ON] mode to protect the projector. When the
projector is in [ON] mode, the picture brightness decreases. When the projector
comes back to normal temperature, the [ECO MODE] returns to [OFF] mode.
Thermometer symbol [ ] indicates the [ECO MODE] is automatically set to
[ON] mode because the internal temperature is too high.