NEC NP-V260 User Manual

v
Important Information
CAUTION:
• DO NOT TOUCH THE LAMP immediately after it has been used. It will be extremely hot. Turn the projector off
and then disconnect the power cord. Allow at least one hour for the lamp to cool before handling.
• When removing the lamp from a ceiling-mounted projector, make sure that no one is under the projector. Glass
fragments could fall if the lamp has been burned out.
Note for US Residents
The lamp in this product contains mercury. Please dispose according to Local, State or Fed-
eral Laws.
Health precautions to users viewing 3D images
Before viewing, be sure to read health care precautions that may be found in the user’s manual included with
your LCD shutter eyeglasses or your 3D compatible content such as DVDs, video games, computer's video
files and the like.
To avoid any adverse symptoms, heed the following:
- Do not use LCD shutter eyeglasses for viewing any material other than 3D images.
- Allow a distance of 2 m/7 feet or greater between the screen and a user. Viewing 3D images from too close
a distance can strain your eyes.
- Avoid viewing 3D images for a prolonged period of time. Take a break of 15 minutes or longer after every
hour of viewing.
- If you or any member of your family has a history of light-sensitive seizures, consult a doctor before viewing
3D images.
- While viewing 3D images, if you get sick such as nausea, dizziness, queasiness, headache, eyestrain, blurry
vision, convulsions, and numbness, stop viewing them. If symptoms still persist, consult a doctor.
- View 3D images from the front of the screen. Viewing from an angle may cause fatigue or eyestrain.
About High Altitude mode
• If you use the projector at altitudes approximately 5500 feet/1700 meters (3000 feet/900 meters on V300X/V300W)
or higher, you are recommended to set [FAN MODE] to [HIGH ALTITUDE]. Failure to do so may cause the projector
to overheat , resulting in malfunction. (→ page 70)
• Using the projector at high altitudes or in low air pressure can shorten the life of components.
About Copyright of original projected pictures:
Please note that using this projector for the purpose of commercial gain or the attraction of public attention in a venue
such as a coffee shop or hotel and employing compression or expansion of the screen image with the following func-
tions may raise concern about the infringement of copyrights which are protected by copyright law.
[ASPECT RATIO], [KEYSTONE], Magnifying feature and other similar features.
This device is not intended for use in the direct field of view at visual display workplaces. To avoid incommoding reflec-
tions at visual display workplaces this device must not be placed in the direct field of view.

NEC NP-V260 Specifications

General

Native aspect ratio	4:3
Projection distance	1.2 - 13 m
Vertical scan range	50 - 120 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	DLP
Contrast ratio (typical)	2000:1
Screen size compatibility	33 - 300 \
Projector native resolution	SVGA (800x600)
Keystone correction, vertical	-40 - 40 °
Focus	Manual
Throw ratio	1.95 - 2.15:1
Zoom capability	Yes
Focal length range	21.83 - 24 mm
RS-232 ports	1
Maximum analog resolution	1920 x 1080 pixels
Lamp type	AC HID
Lamp power	180 W
Light source type	Lamp
Service life of light source	3500 h
Service life of light source (economic mode)	5000 h
DVI port	No
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Component video (YPbPr/YCbCr) in	0
Supported video modes	1080i, 480p, 576i, 576p, 720p
Analog signal format system	NTSC 4.43, PAL, PAL L, PAL M, SECAM
Supported graphics resolutions	1024 x 768 (XGA), 1280 x 1024 (SXGA), 1360 x 768 (WXGA), 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 1600 x 1200 (UXGA), 800 x 600 (SVGA)
RMS rated power	7 W
Placement	Ceiling
Product type	Standard throw projector
Product color	White
Power source	AC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (max)	233 W
Power consumption (standby)	4 W
Power consumption (PowerSave)	0.5 W
Power consumption (economy mode)	210 W
Noise level	34 dB
Certification	CE; ErP; ÜV GS
Noise level (economic mode)	31 dB
Storage temperature (T-T)	-20 - 50 °C
Operating temperature (T-T)	5 - 40 °C
Cables included	AC, VGA
Remote control type	IR
Sustainability certificates	RoHS

Weight and Dimensions

Depth	247 mm
Width	310 mm
Height	95 mm
Weight	2500 g