102
6. Using On-Screen Menu
Setting a new program timer
1. On the PROGRAM TIMER screen, use the SELECT
or
button to select [SETTINGS] and press the EN-
TER button.
The [PROGRAM LIST] screen will be displayed.
NOTE: When the Program Timer is turned on, the [PROGRAM LIST] cannot be edited.
2. Select a blank program number and press the ENTER button.
The [EDIT] screen will be displayed.
3. Make settings for each item as required.
ACTIVE..............................Place a check mark to enable the program.
DAY ...................................Select days of the week for the program. To execute the program from Monday to Friday, select
[MON-FRI].To execute the program in everyday basis, select [EVERYDAY].
TIME .................................Set the time to execute the program. Enter time in 24-hour format.
FUNCTION ........................Select a function to be executed. Selecting [POWER] will allow you to turn on or off the projector
by setting [ADVANCED SETTINGS]. Selecting [SOURCE] will allow you to select a video source by
setting [ADVANCED SETTINGS]. Selecting [LAMP MODE] will allow you to select either [NORMAL]
or [ECO] by setting [ADVANCED SETTINGS].
ADVANCED SETTINGS ......Select power on/off, a type of video source, or lamp mode for the selected item in [FUNCTION].
REPEAT .............................Place a check mark to repeat the program continuing basis. To use the program this week only,
clear the check mark.
To Next Page
Loading...
