115
6. Using On-Screen Menu
[ADVANCED] menu
[CONNECTION] (required for wireless only)
SITE SURVEY:
Displays a list of available SSIDs for wireless LAN on site. Select an SSID which you can access.
To select an SSID, highlight [SSID] and use the SELECT
to select [OK] and press the ENTER button.
: Wireless access point
: Ad Hoc PC
: WEP or WPA enabled
SSID (Network name):
Enter an identifier (SSID) for wireless LAN when selecting [INFRASTRUCTURE] or [AD HOC] in [NETWORK
TYPE]. Communication can be done only with equipment whose SSID matches SSID for your wireless LAN. Up
to 32 alphanumeric characters can be used (case sensitive).
NETWORK TYPE:
Select communication method when using wireless LAN.
INFRASTRUCTURE
.. Select this option when communicating with one or more equipment connected to the wireless or wired
LAN network via a wireless access point.
AD HOC ................. Select this option when using the wireless LAN to directly communicate with a computer in peer-to-peer
mode. This is a method that meets the IEEE802.11 wireless standard.
NOTE: When in Ad Hoc mode, only 802.11b is available for communication method.
Data transmission speed in Ad Hoc mode is limited up to 11Mbps.
CHANNEL:
Select a channel. Available channels vary depending on the country and region.
TIP: When you select [INFRASTRUCTURE], make sure that the projector and your access point are on the same channel;
when you select [AD HOC], make sure that the projector and your computer are on the same channel.
To Next Page
Loading...
