NEC P474W - Page 81

70
5. Using On-Screen Menu
Selecting Communication Speed [COMMUNICATION SPEED]
ThisfeaturesetsthebaudrateofthePCControlport(D-Sub9P).Itsupportsdataratesfrom4800to38400bps.
Thedefaultis38400bps.Selecttheappropriatebaudrateforyourequipmenttobeconnected(dependingonthe
equipment,alowerbaudratemayberecommendedforlongcableruns).
NOTE:Yourselectedcommunicationspeedwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.
Selectingtheserialport[SERIALPORT](notsupportedbyP603X)
Thissetswhichterminalontheprojectorwillreceivetheserialcontrolsignalsforremotelycontrollingtheprojector
fromacommerciallyavailableHDBaseTtransmissiondevices(controlsignalsforturningthepoweronandoff,etc.).
Thereisnoneedtomakethissettingifnotoperatingtheprojectorbyremotecontrol(onlysendingvideoandaudio).
PC CONTROL �������������������������Control signals (RS232C serial communications) are received at the PC CONTROL terminal�
HDBaseT ������������������������������� The video/audio and control signals (RS232C serial communications) are received at the HDBaseT port�
NOTE:
• When[HDBaseT]isset,itwillnotworkwhentheprojectorisinthestandbymode,regardlessofwhether[STANDBYMODE](→page74)
issetto[NORMAL]or[NETWORKSTANDBY](thepowercannotbeturnedon).
 Themethodsbelowcanbeusedtoturnontheprojector’spowerwhenitisinthestandbymode.
• TheprojectorcanbeoperatedbyconnectingthecomputerandprojectorbyRS232Cserialcommunications(ontheprojector,usingthe
PCCONTROLterminalandthePCControlUtilityapplication,with[STANDBYMODE]setto[NETWORKSTANDBY]).
• Theprojectorcanbeoperatedbyconnectingthecomputerandprojectoroverthenetwork(ontheprojector,usingtheLANportandPC
ControlUtilityapplication,with[STANDBYMODE]setto[NETWORKSTANDBY])
TIP:
• WhencontrollingtheprojectorusingtheLANport,thisworkswitheithersetting.
Turning On or Off Remote Sensor [REMOTE SENSOR]
Settheremotecontrolsensorsontheprojector’sfrontandrearpanelsandtheHDBaseTremotecontrolsensor.
Theoptionsare:ALL,FRONT/BACK,FRONT,BACK,andHDBaseT.
(HDBaseTisnotsupportedbyP603X)
NOTE:
• When[HDBaseT]isset,itwillnotworkwhentheprojectorisinthestandbymode,regardlessofwhether[STANDBYMODE](→page74)
issetto[NORMAL]or[NETWORKSTANDBY](thepowercannotbeturnedon).
TIP:
• Iftheremotecontrolsystemdoesnotfunctionwhendirectsunlightorstrongilluminationstrikestheremotecontrolsensoroftheprojector,
changeanotheroption.
• Theremotecontrolsensoronthebackoftheprojectorcannotbeusedwhentheseparatelysoldcablecoverismountedontheprojector.