NEC P502HL-2 - Page 27

27
7. NETWORK SETTINGS
See the table below.
EAP Type Setting Item Note
EAP-TLS User Name 1 character or more and 32 characters or
less
Client Certificate PKCS#12 format file
CA Certificate
(Certicateauthority’scerticate)
DERformatle
PEAP-MSCHAPV2 User Name 1 character or more and 32 characters or
less
Password 1 character or more and 32 characters or
less
CA Certificate
(Certicateauthority’scerticate)
DERformatle
① Selecting [EAP-TLS] for [EAP TYPE]:
The operation for selecting [EAP-TLS], refer the step 3 on this page.
The operation for selecting [PEAP-MSCHAPV2] refer the step 3 on page 28.
3. Focus on [USER NAME] field and press the ENTER button.
The character entry screen (software keyboard) will be displayed. Set a user name.
• Ausernamemustbe1characterormoreand32charactersorless.
4. Focus on [CLIENT CERTIFICATE] and press the ENTER button.
A list of files ([FILES] screen) will be displayed.
• Toreturntothe[AUTHENTICATION]page,presstheEXITbutton.
NOTE:
Installing a digital certificate
Youcaninstalleachdigitalcerticate(clientcerticateandCAcerticate)for[PROFILE1(or2)]onale-by-lebasis.
• InstallarootCAcerticateforaCAcerticate.
• Ifyouinstalladigitalcerticateoveryourexistingdigitalcerticate,theexistingdigitalcerticatewillbeoverwrittenwiththenew
digital certificate.
• Onceadigitalcerticatehasbeeninstalled,itsinformationcannotbedeletedevenifyoustopsettingWPA2-EAP,WPA/WPA2-
EAP.
5. On the [FILES] screen, focus on a digital certificate (PKCS#12 format file) saved in your USB memory device
and press the ENTER button.
The password screen will be displayed.
6. Focus on [PASSWORD] field and press the ENTER button.
The character entry screen (software keyboard) will be displayed. Set the password of the private key. A password
must be 1 character or more and 32 characters or less.
The selected digital certificate file will be installed on the projector.
• WhentherootCAcerticateisnotincludedinthelethatwasselectedinStep5,proceedtoStep7.Whenthe
root certification authority certificate is included, proceed to Step 9.
7. Focus on [CA CERTIFICATE] and press the ENTER button.
The drive list screen will be displayed.
8. On the [FILES] screen, focus on a digital certificate (DER format file) saved in your USB memory device
and press the ENTER button.
• SelectyourrootCAcerticatehere.
The selected digital certificate will be installed on the projector.