NEC P502HL-2 - Multipresenter; Network Service

30
7. NETWORK SETTINGS
7-5. MultiPresenter
Configure the settings when using MultiPresenter.
About the modes
• TheFreemodeisamodeinwhichyoucanconnectfreelytotheprojectorfromtheMultiPresenterapplication
installed on your computer or smartphone.
The screen splitting pattern will vary depending on the number of terminals that are connected. It is also possible
to select the split display or the full-screen display from the terminal.
• TheManagedmodeisamodeinwhichtheoperationsforswitchingbackandforthbetweenthesplit-screendisplay
and the full-screen display when multiple terminals are connected to the projector simultaneously, like in the Free
mode,canbeperformedusingtheprojector's“WebServer”function.
Item Description Remarks
Mode Select the operating mode.
Free: Set the free mode.
Control: Set the managed mode.
The default factory setting when
shippedis“Free”.
HTTP Password AbletosetupapasswordtologintheMANAGEDMODEfor
the MultiPresenter in the WEB SERVER functions
Max 32 alphanumeric charac-
ters. If it leaves in blank, the
passwordbecomes"Null". De-
fault setting: Blank
PINTYPE • ONE-TIME
A 4-digit PIN code is generated automatically. The PIN
code is generated when the projector is turned on, and is
retained until the power is turned off.
• STATIC
Set any 4-digit PIN code.
• Byfactorydefault,thisisset
to [ONE-TIME].
PINCODE When[STATIC]isselectedat[PINTYPE],setanyPINcode. • Thepincodemustconsistof
4 numbers.
UTILIZE PIN CODE
AS CONNECTION
PASSWORD
SetwhetherornottousethePINCODEasthepassword
when connecting the MultiPresenter application to the pro-
jector.
• Notchecked
 DonotusethePINCODEasthepassword.
• Checked
 UsethePINCODEasthepassword.
• Byfactorydefault,thisisnot
checked.
NOTE:
• Ifyouchangethesettingoftheoperatingmode,connectingtotheMultiPresenter,itwillnotbereectedimmediately.Whenthe
MultiPresenterbecomesunusedcondition,thechangeintheoperatingmodewillbereected.
7-6. NETWORK SERVICE
AMX setting
IfyouconnectthisdevicetoanetworkcompatiblewiththeNetLinxcontrolsystemofAMXCorporation,setenableor
disabletodetectthedevicebyAMXDeviceDiscovery.Nocheckmarkisplacedasthedefaultfactorysetting.
SeethewebsiteofAMXCorporationformoreinformationonAMXDeviceDiscovery.
Extron XTP
IfyouconnectthisdevicetotheExtronXTPtransmitter,setenableordisableforconnection.Nocheckmarkisplaced
asthedefaultfactorysetting.SeethewebsiteofExtronElectronicsformoreinformationonExtronXTP.