NEC P502HL-2 - Page 31

31
7. NETWORK SETTINGS
HTTP server configuration
SetthepasswordforloggingintothePROJECTORCONTROLscreen.Amaximumofupto10
alphanumeric characters can be set for the password.
PJLink setting
SettheloginpasswordforusingPJLink.Amaximumofupto32alphanumericcharacterscanbesetforthepass-
word.
Alert e-mail setting
When using this device connected to a network, computers and other devices will be notified of the status of this
device via e-mail if the lamp of this device is due for replacement, or if an error occurs.
ALERTMAIL This option will notify your computer of lamp replace time or error messages via
e-mailwhenusingwiredLAN.
Placing a checkmark will turn on the Alert Mail feature.
Clearing a checkmark will turn off the Alert Mail feature.
Sample of a message to be sent from the projector:
THECOOLINGFANHASSTOPPED.
[INFORMATION]
PROJECTORNAME:PJ-XXXXXXXX
LIGHTHOURSUSED:XXXX[H]
SENDER’SADDRESS Entersender’saddress.
SMTP SERVER NAME Enter the SMTP server name to be connected to the projector.
RECIPIENT’SADDRESS1,2,3 Enteryourrecipient’saddress.Uptothreeaddressescanbeentered.
TESTMAIL Send a test mail to check whether your settings are correct or not.
NOTE:
• Ifyouexecuteatest,youmaynotreceiveanAlertmail.Shouldthishappen,checkif
network settings are correct.
• Ifyouenteredanincorrectaddressinatest,youmaynotreceiveanAlertmail.Should
thishappen,checkiftheRecipient’sAddressiscorrect.
CRESTRON SETTINGS
Configure the settings for connecting this device to a CRESTRON product.
Item Description
ROOMVIEW Check this when controlling the unit with a computer.
CRESTRONCONTROL Check this when controlling the unit with a controller.
IP address Set the IP address of the controller.
IPID SettheIPIDofthecontroller.