NEC PA500U - Mounting The Cable Cover (Sold Separately)

212
9. Appendix
 Mounting the cable cover (sold separately)
Mounting the separately sold cable coveron the projector allows youhide the cables for a cleaner
appearance.
CAUTION
• Aftermountingthecablecover,besuretofastenusingthescrewsprovided.Ifnot,thecablecovercouldfall,
damagingthecablecoverandpossiblyresultingininjury.
• Donotbundlethepowercordandplaceitunderthecablecover.Doingsocouldleadtore.
• Donotapplyexcessiveforcetothecablecover.Doingsocoulddamagethecablecover,resultinginthe
projectorfallingorcausinginjury.
Mounting
Preparations:
1. Connect the power cord and cables to the projector (the connection cords are omitted from the diagrams).
2. Prepare a Phillips screwdriver.
1. Insert the two round protrusions on the left and right edges
of the cable cover into the grooves in the bottom of the
projector to line it up.
NOTE:Becarefulnottoletthepowercordandcablesgetpinchedbythe
cablecover.
2. Turnthecablecoverscrewclockwise.
- Tighten the screw securely.
Removing
1. Turnthecablecoverscrewcounterclockwiseuntilitturns
loosely.
- Hold the cable cover while doing this to prevent it from
falling.
- The screw does not come completely off.
2. Remove the cable cover.
- Turn the cable cover a little, then lift it off.
1
2
1
2